Road American
- This topic has 1 reply, 2 voices, and was last updated 8 months, 3 weeks ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
SS 1 often allows controlled dilution with clean water to adjust sprayability, but the acceptable ratio is formulation specific and must be confirmed on the supplier data sheet. Typical behavior is slow setting, meaning it remains workable longer and breaks as water evaporates and interacts with fines on the surface. Excess dilution can lower residue and delay break, increasing tracking risk and reducing bond strength. Best practice is to measure viscosity after dilution, verify density for rate calculations, and run a short test strip to confirm break time under actual temperature and humidity conditions.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.